Ordering Code for Push-Pull Cable Controls

314  (6) - L - TT - 3 - 144  (AP)

314 (6) L TT 3 144 (AP)
|
Control Type
|
Seal Options
|
Cable Size
|
End Fitting Combination
|
Cable Travel
|
Length
|
Suffix Letters

Control Type
    Low Friction-EXT
       313 - With Stainless Steel End Rods
       314 - With Stainless Steel Support Tubes, and End Rods
       315 - All Exposed Fittings/parts are Stainless Steel

    Utility
       173 - With Stainless Steel End Rods
       174 - With Stainless Steel Support Tubes, End Rods and Innermember Armor
       175 - All Exposed Fittings/parts are Stainless Steel Plus Stainless Innermember Armor


Seal Options
   (Use This Number Only If Requesting Optional Seals)
   6   Model 6 Wiper Seal, Optional on all Controls

Cable Size
Letter End Rod Thread
V 10-32
M 5/16 UNF
L 1/4-28 UNF
H 3/8 UNF
    End Fitting Combination
       T - Threaded Swivil
       G - Groved Swivel


Cable Travel, In Inches (1", 2", 3", 4", 5", 6")

Length, In Inches +/-.25 Inches

Suffix Letters For Additional Features
   (Use Only If Requesting Optional Features)
   N - End Rod Jam Nuts (2 each)
   A - Combination of N and W
   S - Stamp with Cablecraft and Customer Part Number
   W - Extra Shakeproof Washers on Conduit Ends
   P - Stamp with Customer Part Number
   M - Metic End Rods (Optional)

      V - M5 x .8
      L - M6 x 1.0
      H - M8 x 1.25
      H - M10 x 1.5



Push-Pull Cable Specifications

VLD
LD
MD
HD
(Click to see pop up chart of specifications)


Low Friction-EXT and Utility Cables Design Criteria

Efficiency
Efficiency factor ratings are for comparative purposes and may vary due to length, rate of travel, direction of travel, bend radius and temperature.
   To Compare Efficiency;
   Input force = Output load (lbs) x total degrees of bend x efficiency factor + output load.

   Efficiency Factors:

        Low Friction - EXT .0012
        Utility .002

Backlash
    Nominal Backlash = Backlash factor x total degrees of bend.
    Backlash Factors:

       VLD .00015
       LD .00020
       MD .00025
       HD .00030


Temperature range: -65 to +230 F

MINIMUM DUTY BEND. RAD.
VLD 2"
LD 3"
MD 5"
HD 6"
Tewco Inc has been serving Cablecraft, Fumoto, Betts, Tuthill Linkage customers from Wisconsin for over 30 years